Unifire Saw Spezifikationen PDF herunterladen (Seite 3)

Start and Stop

CHAIN BRAKE:

Disengage the cain brake

by pulling the hand gaurd

towards the front handle.

IGNITION:

Move the ignition switch

to start position

CHOKE:

Set the choke control in

choke position.

FAST IDLE:

Combined choke/fast idle

is received when the

choke is moved to choke

position.

This saw is fitted with a

decompression valve (A):

Press the valve to reduce

the pressure in the

cylinder and make starting

easier. Always use the

decompression valve

when starting the saw.

Once the saw has started

the valve will automati-

cally return to its original

setting.

Grip the front handle with

your left hand and hold

the saw down by putting

your right foot in the rear

handle. Pull the starter

handle with your right

hand and pull out the

starter cord slowly until

the starter pawls engage.

Then pull sharply.

Push the choke control

immediately when the

engine ignites and make

repeated starting at-

tempts. When the engine

starts, rapidly give full

throttle. Then the trottle

latch will disengage.

CAUTION! Do not release

the starter handle from

fully pulled out position as

this can cause damage to

the saw.

Stop

Cold Engine

WARNING!

Use the same procedure

as for starting cold engine

but without choke. Fast

idle is received by first set

the choke control in choke

position, and then back

again.

The engine is stopped by

switching off the ignition.

Never start the saw engine without the bar, chain

and clutch cover assembled.

Always move saw away from fueling area.

Place the saw on clear ground, and make sure you

have secure footing

Warm Engine

Start

Page 2

1 2 3 4 5 6 7 8 9 10 11

Kommentare zu diesen Handbüchern

Keine Kommentare